Hxe-10ds Intermediate Copper Wire Drawing Machine with Single Spooler

HXE-10DS Intermediate copper wire drawing machine with single spooler


HXE-10DS Intermediate copper wire drawing machine with single spooler is used to draw single bare copper wire from 3mm(Max) to 0.8mm-2.8mm.

I. Compositions of equipment

II.Parameters
1.Inlet wire diameter 3.0mm(Max.)
2.Outlet wire diameter 0.8mm-2.8mm
3.Speed 520m/min
4.Type Two axis, two capstans
5.Die number 10 (Buyer self prepare)
6.Die dimension Ф30mm×15mmT or Ф25mm×10mmT
7.Slip ratio 17%+10%
8.Control system Traditional analog type
9.Inverter control Dual Inverter control
10.Frame Welded
11.Capstan Tungsten
12.Lubrication Spray
13.Lubrication oil capacity 40L/min
14.Main motor AC 22KW-6
15.Spool motor AC 4KW-4
16.Power source customized

III.HXE-10DT Drawing machine
1.Material:Q235A
2.Structure
2-1.Frame is weld by steel plate, sand blasting and anneal to eliminate the inner stress.
2-2.Further processed by exactitude milling machine.
3.Wire inlet location
3-1.Located on the left of machine.
3-2.Wire inlet protection part equipped, straighten wires to protect.
4.Axes
4-1Material:45# steel.
4-2.Precision: HRC25/27 Eliminate inner stress, improve the rigidity.
5.Capstan 
5-1.Iron cast, 3pcs.
5-2.Loading&unloading the capstans, fixed tightly by cone model.
6.Die Seat
6-1.The 1st and 10th die are independent.The 2nd -9th die are founded by milled iron, small, increase operating room.
6-2.Die seat could be displaced according to the location of capstan.
7.Lubricating
7-1.Over the capstan and dies,set floating water pipe, won't impact the wire pointing.
7-2.The 1st and 10th die, lubricated separately.
7-3.Capacity 40L/min
8.Bobbin size: DIN 400/500mm
9.Traversing
10-1.110W synchronous motor, traverse width 270mm (Max)
10-2.Free rod traverse


Exhibition

Welcome to us